Posted on
Evezor Tobotic arm with milling routing toolhead

3D Contour Milling

Today we contour milled the letter P in some Brazilian cherry

Our toolhead today is a full size 2hp router with a 1/4″ ballmill.

The stock material is a laminated piece of Brazillian cherry between two pieces of pine.

The toolpath was created with Kiri:Moto. With all these projects, for better or worse, I tried my best to use open source software.

I would have made a tutorial on this if I didn’t have such a bad experience using the software. It’s not the worst software ever but made some unusual decisions with some of its toolpaths.

I will be looking for some better software, if  you have some suggestions please leave a comment.

Leave a Reply

Your email address will not be published. Required fields are marked *