Posted on

2.5D Milling

Today We Mill The Open Source Logo



Our toolhead today is a full size 2hp router with a 3/8″ 2 flute bit.

The stock material is a laminated piece of brazillian cherry between two pieces of pine.

The toolpath was created with Kiri:Moto. With all these projects, for better or worse, I tried my best to use open source software.  I would have made a tutorial on this if I didn’t have such a bad experience using the software. It’s not the worst software ever but made some unusual decisions with some of its toolpaths. I will be looking for some better software, if  you have some suggestions please leave a comment.



Leave a Reply

Your email address will not be published. Required fields are marked *